Browse Articles
Discover research articles across all indexed journals
The effects of dry density and moisture content on the shear characteristics of clay-type muddy interlayer
Severe decline of Gongolaria barbata (Fucales) along most of the French Mediterranean coast
Risk assessment of femoral head AVN following reduction and fixation of intracapsular hip fractures in patients younger than 65 years over a 10 year follow up
Research on rechargeable agricultural wireless sensor network based on ZigBee immune routing repair algorithm
Nonlinear mixed-effects models to analyze actin dynamics in dendritic spines
Oral colonization of antimicrobial-resistant bacteria in home health care participants and their association with oral and systemic status
Multiple objectives escaping bird search optimization and its application in stock market prediction based on transformer model
Carotid revascularization improves cognition in patients with carotid stenosis
Examination of factors associated with physical activity among medical students pre and post-COVID-19 in Serbia
Towards a reduced order model of the periodontal ligament
Abstract Based on previous in vitro experiments with specimens of porcine mandibular premolars, the simulation of the periodontal ligament response to force in the initial phase of orthodontic tooth movement is described. The initial response of the periodontal ligament can be simulated with a poro-visco-hyperelastic model. For the ground substance a hyperelastic constitutive model for compressible material was used. To facilitate parameter identification a reduced order model and an optimal interpolation metamodel were used. Parameters for the constitutive model identified herein are in good agreement with published values. They indicate a high initial compressibility of the periodontal ligament, which may be attributed to the compressibility of the vascular system within the periodontal ligament. Dimensionless analysis suggests that poroelastic behaviour will gradually cease when viscoelastic relaxation progresses. This was observed as well in the simulation and confirmed by varying the poroelastic model parameters within physically justified limits. Alveolar bone permeability has a significant influence on the flow of pore fluid in the periodontium due to poroelasticity. It is argued that in vivo alveolar bone perforation may adapt locally to optimise for the predominant load situation. A strain rate hardening effect was observed, which is not covered by the simulation, and may be the subject of further investigations.
A recursive embedding and clustering technique for unraveling asymptomatic kidney disease using laboratory data and machine learning
Non-fasting and fasting serum triglyceride concentrations and new-onset hyperuricemia in the general Japanese population: ISSA-CKD study
Stacked encoding and AutoML-based identification of lead–zinc small open pit active mines around Rampura Agucha in Rajasthan state, India
Frequency stability improvement in EV-integrated power systems using optimized fuzzy-sliding mode control and real-time validation
Development of an adaptive meshing upper bound limit analysis method for large deformation axisymmetric geotechnical problems
A hybrid optimization-enhanced 1D-ResCNN framework for epileptic spike detection in scalp EEG signals
Decoding the heterogeneous subpopulations of glioblastoma for prognostic stratification and uncovering the promalignant role of PSMC2
Dense convolution-based attention network for Alzheimer’s disease classification
Surrogate sensitivity analysis of facet optical coatings produced without and with in situ design reoptimization
Abstract Optoelectronic and photonic waveguide-based devices often require the control of the exit/entrance facet reflectance to a high degree of precision on a relatively large wavelength range. Fabricating facet optical coatings for that purpose can be challenging due to thickness errors. In this work, a surrogate approach, the polynomial chaos expansion method, is used to evaluate the robustness of optical coating designs to experimental errors, and the Sobol’ sensitivity indices of their individual layers. The effect of a fabrication strategy involving successive in-situ design re-optimizations after completion of each individual layer deposition is simulated and shown to reduce significantly the detrimental effect of thickness errors on the yield and performance of coatings.