Impact of threading dislocations on the V-defect assisted lateral carrier injection and recombination in InGaN quantum well LEDs

R Rinat Yapparov (Department of Applied Physics, KTH Royal Institute of Technology, AlbaNova University Center 1 , 10691 Stockholm,) A Alejandro Quevedo (Electrical and Computer Engineering Department, University of California Santa Barbara 1 , Santa Barbara, California 93106,) T Tanay Tak (Materials Department, University of California 1 , Santa Barbara, California 93106,) S Shuji Nakamura S Steven P. DenBaars (Electrical and Computer Engineering Department, University of California Santa Barbara 1 , Santa Barbara, California 93106,) J James S. Speck (Materials Department, University of California Santa Barbara 2 , Santa Barbara, California 93106,) S Saulius Marcinkevičius (Department of Applied Physics, KTH Royal Institute of Technology, AlbaNova University Center 1 , 10691 Stockholm,)

Abstract

The nonuniform hole distribution between InGaN quantum wells (QWs) of light emitting diodes (LEDs) has a negative impact on LED efficiency. The uniformity can be increased by using lateral hole injection through sidewalls of V-defects, which form at threading dislocations. However, the inherent coupling between the V-defects and dislocations might affect efficiency of the hole injection and nonradiative recombination. In this work, we have tested the possible impact of the dislocations on the injection and recombination by means of scanning near-field electroluminescence and photoluminescence spectroscopy on single green-emitting InGaN QW LEDs containing large (∼0.5 μm) V-defects. The measurements have not provided any evidence of a lower hole injection efficiency or enhanced nonradiative recombination at the dislocations located at the V-defect facets or their apexes. This shows that large V-defects are excellent volumetric injectors for long wavelength InGaN LEDs. Furthermore, it was established that V-defects are preferential hole injectors even in single quantum well devices. Compared to vertical injection, the V-defect injection allows lowering the operating voltage, which should contribute to an enhanced wall plug efficiency.

Article Details

Volume / Issue Vol. 126, Issue 21
Published May 26, 2025
ISSN 0003-6951
Publisher American Institute of Physics

Journal Info

Applied Physics Letters

American Institute of Physics

ISSN: 0003-6951 Physical Sciences

Authors (7)

R

Rinat Yapparov

Department of Applied Physics, KTH Royal Institute of Technology, AlbaNova University Center 1 , 10691 Stockholm,

A

Alejandro Quevedo

Electrical and Computer Engineering Department, University of California Santa Barbara 1 , Santa Barbara, California 93106,

T

Tanay Tak

Materials Department, University of California 1 , Santa Barbara, California 93106,

S

Shuji Nakamura

S

Steven P. DenBaars

Electrical and Computer Engineering Department, University of California Santa Barbara 1 , Santa Barbara, California 93106,

J

James S. Speck

Materials Department, University of California Santa Barbara 2 , Santa Barbara, California 93106,

S

Saulius Marcinkevičius

Department of Applied Physics, KTH Royal Institute of Technology, AlbaNova University Center 1 , 10691 Stockholm,