Browse Articles
Discover research articles across all indexed journals
Theoretical study of the structure and vibrational sum frequency generation spectroscopy of liquid–vapor interface of aqueous acetic acid
We have investigated the liquid–vapor interface of aqueous acetic acid solution through calculations of the structure and vibrational sum frequency generation (VSFG) spectra of the interfaces for varying concentrations of the acetic acid (AA). Our findings reveal the surface propensity of the AA molecules. As the concentration of AA increases, more AA molecules are found to be present in the interfacial region. The AA molecules at the interface are found to be oriented in a manner where the hydrophobic part (methyl chain) is oriented toward the vapor phase and the hydrophilic part is pointed toward the liquid phase. The total VSFG spectrum reveals that the intensity of the peak of dangling OH groups of water around 3750 cm−1 decreases when the concentration of AA increases, while the intensity of the peak around 3550 cm−1 due to OH groups having hydrogen bonds between water and AA molecules increases. Furthermore, the latter peak is redshifted as the AA concentration increases, which is due to the partial cancellation between the positive response of water OH modes and the negative response of the OH modes of AA molecules. It is also noted that the AA molecules make the interfacial water more structured by making hydrogen bonds with its otherwise dangling OH modes at the surface.
First-in-human exploratory trial assessing safety, feasibility, and efficacy of artificial protein (silk-elastin) in promoting healing in patients with meniscus injuries
Abstract Meniscal tears, especially those in avascular regions, pose a significant risk for osteoarthritis if repair fails. While meniscal repair is the preferred method for preserving knee function, it often has a high failure rate in avascular zones. This study aimed to evaluate the safety and potential efficacy of silk-elastin (SE), an artificial protein with wound-healing properties, for enhancing meniscal repair. Eight patients with meniscal tears in avascular areas underwent arthroscopic repair followed by SE application, including cases of lateral and medial tears, discoid lateral meniscus, and bucket-handle tears. No adverse events or reactions were attributed to SE. At 3 months post-surgery, clinical outcomes and repair sites were evaluated using MRI and arthroscopy. Significant improvements were observed in Lysholm and visual analog scale scores ( P < 0.05), with the knee injury and osteoarthritis outcome scores showing significant improvement in the symptom subscale. MRI findings indicated one patient with grade 1 healing, three with grade 2, and four with grade 3 (unhealed). Arthroscopically, six patients demonstrated completely healed menisci, while two showed incomplete healing; none were classified as “unhealed.” These findings suggest that SE is safe and may support meniscal healing in avascular zones, indicating its potential to improve repair outcomes.
Considerable spin asymmetry of deep valence states induced by partial neutralization of charged SrTiO3(011) surfaces
Recently, spin asymmetry in O 2p related deep valence states was evidenced in SrTiO3(001) [Popescu et al., Phys. Scr. 99(10), 105925 (2024)]. In this work, we report the detection of a much higher (about four times) spin asymmetry in SrTiO3(011) by spin resolved photoelectron spectroscopy, with samples characterized also by core level x-ray photoelectron spectroscopy and low energy electron diffraction. The explanation of a so important spin asymmetry is related to the partial neutralization of O2(4−) or SrTiO(4+) end layers. Missing electrons from O 2p states in the case of O2 terminations enable robust atomic spins, according to Hund’s rule. The parallel analysis of core level shifts for surface atoms and the amplitude of spin asymmetry suggests that 50% of the oxygens from the surface SrO layer of SrTiO3(001) have a 2p5 configuration with an unpaired electron (the rest are in a 2p6 configuration), while in the case of O2 terminated SrTiO3(011), about 50% of surface oxygens have a 2p5 configuration and 50% of surface oxygens are neutral (2p4), yielding a net charge per O2 surface unit cell of (−1) instead of (−4). The magnetization is oriented along the rows formed by the (4 × 1) reconstruction in the 01̄1 in-plane direction.
Determination of 5-fluorouracil anticancer drug solubility in supercritical CO2using semi-empirical and machine learning models
How my research focus exposed me to threats and harassment
Shock compression of liquefied gases: Molecular dissociation and radiance change at the sample/LiF interface
This study investigates the behavior of nitrogen and other liquefied gases under shock compression, with a focus on temperature variations and molecular dissociation. Through dynamic compression experiments on liquefied Ar, O2, CO, and N2, we aimed to understand shock-induced cooling and radiance changes at the sample/lithium fluoride (LiF) interface. The experiments were conducted using a setup involving a Doppler pin system and pyrometer to measure shock velocities, pressures, and temperatures across the interface between shocked liquids and LiF. Under the first-shock, molecular liquids experienced partial dissociation due to a rapid rise in pressure, density, and temperature within nanoseconds. Upon re-shocking at the sample/LiF interface, a radiance drop was observed for all liquids except Ar. Our data analysis suggests that the cooling effect is likely due to a chemical reaction occurring at the interface between reactive species, produced during the initial shock, and the layer of LiF at the surface under re-shock conditions. One probable interpretation is that this reaction formed a thin, partially transparent layer on the LiF, which absorbed a significant portion of the radiation emitted by the shocked fluid. Thus, the observed temperature drop in re-shocked liquid nitrogen is likely attributable to radiation reduction.
Focal adhesion kinase promotes aerobic glycolysis in hepatic stellate cells via the cyclin D1/c-Myc/MCT-1 pathway to induce liver fibrosis
Polyampholyte sequence controls the type of electrostatic coil-globule transition in good solvent
Coarse-grained molecular dynamics simulations are employed to explore the conformational behavior of globally neutral polyampholytes under good solvent conditions. The interplay between non-Coulomb repulsions and sequence-dependent Coulomb attractions of monomers results in qualitatively different types of electrostatically driven chain contraction for diblock, random, and alternating statistics. At increasing the solution Bjerrum length lb, diblock and random polyampholytes exhibit a smooth coil-globule crossover, with the globule size continuously decreasing with lb according to the theoretical power laws. This confirms the scaling picture of the globule interior consisting of oppositely charged blobs attracting each other via long-range electrostatic forces and repelling via short-range two-body interactions. In contrast, alternating polyampholytes collapse completely analogously to neutral chains because Coulomb interactions in them are effectively dipole–dipole short-range. The transition region shrinks with increasing chain length, implying phase transition behavior in the limit of infinitely long chains. These collapse curves fall on the universal master curve, which is well-fitted by the theory of coil-globule transitions and demonstrates that Coulomb interactions in alternating polyampholytes renormalize (reduce) the dimensionless second virial coefficient by δB∝−lb2. This study highlights the profound impact of primary sequence on the conformational behavior of charge-balanced polyampholytes in good solvents, particularly the nature of the electrostatically driven coil-globule transition they undergo.
Towards autonomous robotic THz-based in vivo skin sensing: the PicoBot
Abstract Terahertz (THz) light has the unique properties of being very sensitive to water, non-ionizing, and having sub-millimeter depth resolution, making it suitable for medical imaging. Skin conditions including eczema, psoriasis and skin cancer affect a high percentage of the population and we have been developing a THz probe to help with their diagnosis, treatment and management. Our in vivo studies have been using a handheld THz probe, but this has been prone to positional errors through sensorimotor perturbations and tremors, giving spatially imprecise measurements and significant variations in contact pressure. As the operator tires through extended device use, these errors are further exacerbated. A robotic system is therefore needed to tune the critical parameters and achieve accurate and repeatable measurements of skin. This paper proposes an autonomous robotic THz acquisition system, the PicoBot, designed for non-invasive diagnosis of healthy and diseased skin conditions, based on hydration levels in the skin. The PicoBot can 3D scan and segment out the region of interest on the skin’s surface, precisely position (± 0.5/1 mm/degrees) the probe normal to the surface, and apply a desired amount of force (± 0.1N) to maintain firm contact for the required 60 s during THz data acquisition. The robotic automation improves the stability of the acquired THz signals, reducing the standard deviation of amplitude fluctuations by over a factor of four at 1 THz compared to hand-held mode. We show THz results for skin measurements of volunteers with healthy and dry skin conditions on various parts of the body such as the volar forearm, forehead, cheeks, and hands. The tests conducted validate the preclinical feasibility of the concept along with the robustness and advantages of using the PicoBot, compared to a manual measurement setup.
Have Trump’s anti-DEI orders hit private funders? HHMI halts inclusive science programme
Data-driven signal-to-noise enhancement in scattering near-field infrared microscopy
This study introduces a machine-learning approach to enhance signal-to-noise ratios in scattering-type scanning near-field optical microscopy (s-SNOM). While s-SNOM offers a high spatial resolution, its effectiveness is often hindered by low signal levels, particularly in weakly absorbing samples. To address these challenges, we utilize a data-driven “patch-based” machine learning reconstruction method, incorporating modern generative adversarial neural networks (CycleGANs) for denoising s-SNOM images. This method allows for flexible reconstruction of images of arbitrary sizes, a critical capability given the variable nature of scanned sample areas in point-scanning probe-based microscopies. The CycleGAN model is trained on unpaired sets of images captured at both rapid and extended acquisition times, thereby modeling instrument noise while preserving essential topographical and molecular information. The results show significant improvements in image quality, as indicated by higher structural similarity index and peak signal-to-noise ratio values, comparable to those obtained from images captured with four times the integration time. This method not only enhances image quality but also has the potential to reduce the overall data acquisition time, making high-resolution s-SNOM imaging more feasible for a wide range of biological and materials science applications.
Active frequency support capability evaluation of photovoltaic stations based on bi-level evaluation method
Superoxide anion (O2−) collisions with CO2 molecules in the energy range of 50–950 eV
A novel gas-phase molecular scattering study is reported for O2− collisions with CO2 for impact energies ranging from 50 to 950 eV in the lab frame. The absolute total electron detachment, relative total, and partial ionization cross sections have been measured within this energy range together with the positive ion yields. The primary anionic beam projectile is produced in a pulsed hollow cathode discharge induced plasma, and its interactions with the neutral molecular target occur in a gas cell at a well-known constant pressure. For impact energies above 500 eV, high mass (m &gt; 44 u) charged complexes have been detected. With the aid of a theoretical study using ab initio methods, we propose a mechanism to infer the formation of these cationic species, which have been assigned to projectile–target stable compounds (CO3+ and CO4+).
HMGB-1 as a predictor of major bleeding requiring activation of a massive transfusion protocol in severe trauma
When theory meets experiment: What does it take to accurately predict 1H NMR dipolar relaxation rates in neat liquid water from theory?
In this contribution, we compute the 1H nuclear magnetic resonance (NMR) relaxation rate of liquid water at ambient conditions. We are using structural and dynamical information from Coupled Cluster Molecular Dynamics (CCMD) trajectories generated at CCSD(T) electronic structure accuracy while also considering nuclear quantum effects in addition to consulting information from x-ray and neutron scattering experiments. Our analysis is based on a recently presented computational framework for determining the frequency-dependent NMR dipole–dipole relaxation rate of spin 1/2 nuclei from Molecular Dynamics (MD) simulations, which allows for an effective disentanglement of its structural and dynamical contributions and includes a correction for finite-size effects inherent to MD simulations with periodic boundary conditions. A close to perfect agreement with experimental relaxation data is achieved if structural and dynamical information from CCMD trajectories is considered, leading to a re-balancing of the rotational and translational dynamics, which can also be expressed by the product of the self-diffusion coefficient and the reorientational correlation time of the H–H vector D0 × τHH. The simulations show that this balance is significantly altered when nuclear quantum effects are taken into account. Our analysis suggests that the intermolecular and intramolecular contributions to the 1H NMR relaxation rate of liquid water are almost similar in magnitude, unlike what was predicted earlier from fully classical MD simulations.
A deep-learning approach to parameter fitting for a lithium metal battery cycling model, validated with experimental cell cycling time series
Combining crystal planes and heterojunctions of ZnS/SnS2 boosts photocatalytic performance
A reasonable construction of hybrid heterogeneous photocatalysts possessing fast charge separation and transfer and visible light utilization ability is of great significance for enhancing and achieving highly efficient photochemical conversion. In this study, a series of ZnS/SnS2 heterojunction photocatalysts were prepared by a morphology-controlled strategy, and the regulation of ZnS/SnS2 heterostructure was realized for the photodegradation of methyl violet (MV) under visible light. The results show that as-prepared ZnS/SnS2 consists of hybrid morphological microparticles and exhibits a nanoparticle/nanosheet interspersed structure. The multi-touch interface of the constructed heterostructures can significantly shorten the carrier transport path and greatly promote the charge separation and transfer under the action of the local electric field at the semiconductor/semiconductor interface. Exposed dual-crystal planes of SnS2 coupled with ZnS enrich the active sites and enhance the performance of pure SnS2 and ZnS material. The degradation rate of MV over the optimal heterojunction material (ZnS/SnS2-50) exceeds 91.4% within 90 min under visible light irradiation, which is about 62 times that of MV compared with pristine ZnS.
Clinical characteristics, metastasis patterns, and treatment outcomes of HER2-low breast cancer
Investigation on phase formation and thermoelectric transport properties of CoTe2–CoSe2 solid solution alloys
CoTe2 and CoSe2 alloys have garnered considerable attention in thermoelectric applications due to their high electrical conductivity, tunable electronic properties, and potential for high power factors. In this study, the phase formation behavior and thermoelectric transport properties of a CoTe2–CoSe2 solid solution alloy were investigated by synthesizing a series of Co(Te1−xSex)2 compositions, where x = 0, 0.25, 0.50, 0.75, and 1.0. For x = 0, 0.25, and 0.50, the orthorhombic phase of CoTe2 was observed, while for x = 0.75, the orthorhombic phase of CoTe2 and cubic phase of CoSe2 coexisted. Up to x = 0.50, the power factor decreased slightly as the Hall mobility and the density-of-state effective mass decreased. The total thermal conductivity decreased as x increased to 0.50, owing to a decrease in the electronic and lattice thermal conductivity. Despite the decrease in total thermal conductivity, no significant increase in zT values was observed in the range of x = 0.25–0.50 due to a more pronounced decrease in the power factor. Nevertheless, cubic phase CoSe2 exhibited higher power factors and thus higher zT of 0.13 at 700 K. Further analysis based on single Kane band model suggests that significant enhancement in the power factor and zT could be achieved by reducing the carrier concentration from ∼1021 to ∼1019 cm−3 for all compositions.