Simultaneous determination of moisture, 1,2-propanediol, glycerol and menthol in tobacco products using GC-TCD&FID in parallel method

Y Yaping Ma Q Qinlin Xiao L Li Li J Juan Yang J Jing Wen Y Yuyang Deng J Jia Guo X Xixiang Zhang (Material Science and Engineering Program, Division of Physical Science and Engineering, King Abdullah University of Science and Technology (KAUST), Thuwal, Kingdom of Saudi Arabia.) W Wu Wen Y Yi Shen (College of Chemistry, Chemical Engineering and Materials Science, and State Key Laboratory of Radiation Medicine and Protection)

Abstract

Abstract Moisture, 1,2-propanediol, and glycerol are crucial quality indicators in the production and application of novel tobacco products and reconstituted tobacco leaves. However, accurately measuring these components simultaneously remains a challenge. In this study, a method applying GC-TCD&FID method for the simultaneous determination of moisture, 1,2-propanediol, glycerol and menthol was developed. The results showed that: (1) all four components exhibited good linearity, with correlation coefficients (R 2 ) above 0.995 for water and above 0.999 for three alcohols. Recoveries ranged from 94.49 to 102.83%, and repeatability RSD ranged from 1.25 to 2.33%. The detection limit for water was 0.32 mg/mL, and the alcohols ranged from 0.04 to 0.21 mg/mL. (2) Sample pretreatment and GC analysis were combined into a single step, reducing reagent use, workload, and total analysis time by about 50%. Anhydrous ethanol replaced methanol as the solvent, aligning the method with green and low-carbon principles. This approach has been validated and successfully applied in production over the past 3 years, demonstrating its reliability and practicality.

Article Details

Volume / Issue Vol. 15, Issue 1
Published July 09, 2025
ISSN 2045-2322
Publisher Nature Portfolio

Journal Info

Scientific Reports

Nature Portfolio

ISSN: 2045-2322 Open Access Life Sciences

Authors (10)

Y

Yaping Ma

Q

Qinlin Xiao

L

Li Li

J

Juan Yang

J

Jing Wen

Y

Yuyang Deng

J

Jia Guo

X

Xixiang Zhang

Material Science and Engineering Program, Division of Physical Science and Engineering, King Abdullah University of Science and Technology (KAUST), Thuwal, Kingdom of Saudi Arabia.

W

Wu Wen

Y

Yi Shen

College of Chemistry, Chemical Engineering and Materials Science, and State Key Laboratory of Radiation Medicine and Protection